This research is the development of an energy - saving water planting kit. The objective is to develop a prototype of an energy - saving water planting kit by applying solar energy as an energy source that is controlled by the Arduino board through a blynk application and study the efficiency of the water culture planting kit. By comparing electricity usage rates between solar energy and electric power from the household. In this study there were 4 experimental sets. The experiment was water cultivation without installation 2 experimental sets and 2 experimental sets were installed using green salad vegetables. In research the 45 days growth period consisted of leaf length and width root length number of leaves and height. There is also a comparison of the efficiency of AB fertilizer and soy milk hormones to reduce chemical usage. The research has shown that the use of the soybean milk hormone provided a high growth rate of Lactuce sativaVar. Longifolla than AB fertilizer. There are many nutrients but only in small amounts. When used as a nutrient for plant growth needs to be changed daily. Considering the economic value using AB fertilizer as a nutrient will be worth more than soy milk hormones. For the installation of the instruction set and the LED lamp was suitable for Lactuce sativaVar. Longifolla growing than not installing the instruction set and the LED lamp. These can save electricity cost of 85 baht per month.

This paper proposes the bidirectional resonant converter with duty cycle voltage control using for CCTV with solar energy. The converter designed at 20 KHz for 20 W with 92.85 % of efficiency is operated at zero voltage switch mode for reducing the losses of converter. The modes of operation divide in two modes for operating bidirectional current. The first part is buck mode which has 5 volt at the output voltage and second is boost mode which has 8 volt at the output voltage. The two operation modes of converter will be discussed in this paper.

In this research from the whispering gallery modes generated by micro PANDA ring resonator the reduced trapping harmonics potential in the short range regime where the interaction was represented by a coupling between ions – electric field were established and analyzed. It was found that the deep potential well was proportional to electric intensity and the damping polarized transition rate of the dipole. The application of this trapping potential in quantum information engineering was showed many good evidences such as quantum CNOT gate for both single and two qubits as well.

The hybrid materials of lead sulfide with montmorillonite were synthesized by a solid-solid reaction between lead-exchanged montmorillonite and sodium sulfide at ambient condition. The hybrids were characterized by powder X-ray diffraction (XRD) thermogravimetric-differential thermal analysis (TG-DTA).The basal spacing of heat-treated lead sulfide-montmorillonite-sodium sulfide (200oC) was 1.20 nm. The formation of lead sulfide in the hybrid confirmed by the non-resolved absorption band and absorption onset at 328 and 508 nm respectively for heat-treated lead sulfide-montmorillonite-sodium sulfide. The dramatic blue-shifted in the absorption onset relative to that of bulk was observed.The heat treated lead sulfide-montmorillonite-sodium sulfide showed an emission peak at 367 nm. The removal of adsorbed water resulted in the increasing intensity of the hybrid.

This paper presents the method to reduced electromagnetic interference from electronic drive for LED lamp to achieve the TIS standard No.1955-2551. According to standard it must have been tested for magnetic field compatibility that are included Magnetic Field Emission: ME Conducted Emission: CE and Coupling Decoupling Network: CDN. The 3 LED lamp which defined as Type A B and C were tested. Each lamps has 16 watt electric power and was different electromagnetic interference of electronic drive. After that the reduce electromagnetic interference circuit has been designed for low frequency. This circuit test was based on Conducted Emission test only. The integrated design was preferable to reduces electromagnetic interference for LED lamp drive device type A to the TIS. standard No. 1955-2551. That design circuit was been trialled in LED lamp drive device type B and C in order monitor efficiency of reduce electromagnetic Interference. The results showed that design circuit can reduce electromagnetic interference from LED lamp drive device type A and B to the standard. For LED lamp drive device types C the design circuit can reduce electromagnetic interference but it still has not achieve the standard.