As the worlds energy resources are currently insufficient to meet human needs energy-saving and energy-efficient appliances have to be invented that are readily available and accessible to everyone. To have enough energy to meet human needs and to reduce the waste from the waste of energy resources each year to meet the demand for energy that can be produced by itself. This research presents the construction of a portable DC to AC voltage converter or “Constrution of Portable DC to AC Voltage Converter” which can be operated through a solar cell. By charging energy from the sun and storing energy at the battery. and can also bring electrical energy to use inside the pressure converter There is an inverter circuit that converts voltage from DC to AC so that AC power can be used in daily life. which has a lighting system power socket USB port and helps reduce electricity bills in the house and is convenient to carry From the experimental results of creating a portable DC to AC voltage converter it can be used in daily life and saves electricity and is also clean energy from sunlight that does not cause pollution like a generator that uses oil. be a generator

System of The Provincial Electricity Authority using the grounding wire connected between the cable end and Surge arrester format it is connect the cable from the end of the cable set to the end of the Surge arrester and grounded wire that splits the ground between the cable connecting point and the Surge arrester format it is a separate grounding connecting point to the cable end and Surge arrester on both sides of cable riser pole by Computer program. Resulting from computer analysis and the comparison of line setting found that if setting line lead to ground and join with ending cable line and Surge arrester lead in to line voltage drop less than setting line to ground with separate line and Surge arrester.

This thesis presents a method of compare the reducing high voltage source more than necessary to the pilot study two plants in case of load near power station the same distance but different. There are 2 methods first method reducing the voltage by adjusting tap transformer. Other method installed by voltage equipment. Regulator in a factory used 2 methods for measured the value of voltage before&after and continued to reduce the voltage until minimum loading that this factory can normal operate. From two trials we found that reducing the voltage by installation voltage regulator/voltage equipment can save more energy cost 10.23% than adjusting tap transformer that can save only 4.66%. And analysis of Specific Energy Consumption (SEC) by reducing the voltage level of the industry. Energy consumption kWh per 1 output (plastic bottles) Then lower from 0.119 kWh per 1 bottle remaining 0.089 kWh per 1 bottle This is in line with the energy analysis that main control electric power.

The fault in a power distribution system disturbs the power dispatch under normal conditions therefore decreases the quality of the electric power. The single line to ground fault is an asymmetric fault that may have a high percentage chance to happen. The kind of fault changes power and voltage dramatically. The size of the phase voltage decreases which affect the economic damage of the system. This paper presents an analysis of grounding systems to reduce voltage drop in a power distribution system by using the technical analysis system in case of one phase to ground fault. The objective is to minimize voltage drop for users using the simulation with single line to ground fault in distribution system voltage level at 22 kV PEA’s test system. The simulation utilizes the EMTDC-PSCAD program. The results show that the grounding method can reduce the voltage drop and reduce the damage of the economic system