Nowadays the Thailand automotive industry widely grows. Brakepad is one of the automotive productions that role to automotive industry because it is the most critical security parts. Consequently testing products for quality are extremely requested. However the equipment and function tests are not enough and are also high cost so it cannot supports to the automotive industry development. In this work the initiation and design of frictional test were carried out. The testing procedure is referred to The special test jigs for friction measurements JIS K7125[5] and Clutch facings for automobiles JIS D4311[6].A study of the frictional test emphasize on the static friction(l-ls) and kinetic friction(l-lk) in different condition. There are 3 specimens of brake pad supported by the industry company. These specimens were test and compared between the pin on disks result and the friction testings result. The two-sided results from the analysis correspond but the pin on disks friction coefficient is more than the friction testings friction coefficient by 19.56%. Moreover the coefficient of friction tends to follow the temperature. Besides the static friction(l-ls) is likely more than kinetic friction(l-lk) and will be high difference in high pressure condition.

The objectives of this research are to study the rate of deterioration of tyre friction coefficient and investigate the quality of new and old tyres that are currently in use. A set of the rolling resistance testing was designed and set up to work with the single dynamometer according to speed 80 km/h tire load 4660 N and inflation pressure 30 psi. There were three tire samples new tire one year used tire and two year used tire to find the rolling resistance coefficients. The finding shows that the rolling resistance was inverse variation with tire aging. For instance the new tire (1st sample) had the highest rolling resistance on the other hand the two year used tire (3th sample) had the lowest rolling resistance. Moreover the rolling resistance coefficients were inverses variation with tire aging. Besides the one year used tire had the average of the decreasing rate of the rolling resistance coefficient at 0.03689 N/kN per a week while the two year had the average of the decreasing rate of the rolling resistance coefficient at 0.03671 N/kN per a week. Furthermore the result also revealed that the rolling resistance coefficients nonlinearly decreased comparing to the tire aging.

Aluminium was used in many industrial applications due to good properties such as ductile high corrosion resistant and high electrical conductivity. Since wear resistance of aluminium was very poor so that it was a limitation of using this material in several conditions. In this research aluminium was improved the wear resistance properties by using anodizing process and adding some titanium dioxide particles on the surface. The effect of anodizing process duration on the wear resistence property was studied. It was found that the process duration and amount of titanium dioxide play the important role on improvement of tribological properties of aluminium.

Brake system is used the friction between disk and pads. In the driving conditions the brake behavior from the driver is difference. Based on this reason the damage on disk and pads are occurring. Nowadays the ratio of compound materials in pads is several and involved automotive industry has not available enough to experiment. Thus it is difficult to brake pads damaged analyzing in several driving conditions. In this problem the mechanical property tester is main tool for experimental works and test procedure base on the Brake lining and disc brake pads compressibility JIS D 4413. The experiment emphasizes on the flexibility behavior and internal energy by volume with 3 types of brake lining and pads. For the experiment focused on conditions by normal apply brake repeat apply brake and suddenly apply brake. The results revealed the normal apply brake condition the maximum and minimum of flexibility behavior was appeared on brake lining and pads type A and type C with testing temperature at 200C. By the repeat and suddenly apply brake conditions the brake lining and pads type C and type A with 300C is given to the maximum and minimum flexibility behavior. In case of internal energy by volume the maximum and minimum energy was appeared on pads type C and type B at the 30C of testing temperature. For the testing temperature at 200 and 400C the pads type A and type B were got the maximum and minimum energy respectively. On the other hand at the high flexibility behavior is given to high internal energy at the high temperature of the apply brake condition.