Durian has been very popular not only local people but also tourists. As a result there are many durian peels wasted so this research is explored the utilization of durian peels. Durian rind is a biological waste but contains high amount of crude fiber. This research aims to study using durian rind powder to replace wheat flour in butter cakes at 5 10 and 15 % (w/w) (DRB-5 DRB-10 and DRB-15). Physical properties chemical composition and sensory evaluation of the butter cakes were analyzed. The results showed that durian rind powder contained 51.43 % of crude fiber. Increasing of durian rind powder in butter cakes showed significant decreasing of lightness (L*) blue–yellow component (b*) springiness and cohesiveness values while green–red component (a*) hardness and gumminess values were significantly higher than the control sample (BC) (p≤0.05). Dietary fiber content of the products shown significantly increased by 13.98% for DRB-5 48.92 % for DRB-10 and 54.84% for DRB-15 as compared with BC (p≤0.05). The acceptance scores of DRB-5 including appearance odor taste texture and overall liking scores were highest. There are 300.28 kcal for 1 serving of butter cake which contain 1.70 gram of dietary fiber. However durian rind powder can be used as a food ingredient and source of dietary fiber in other food recipes for further studies.

The enhancement of mechanical properties of natural rubber vulcanisates was expected by surface modification of perlite particles. Thus the objective of the present study was to investigate the cure properties and the heat aging resistance properties in terms of stress at 100% elongation tensile strength and percentage elongation at break after surface modification. Furthermore the rebound resilience and abrasion resistance of perlite treated with silane filled in NR vulcanisates were investigated. In a comparison the properties of clay-filled NR vulcanisates were determined. The results reveal that surface modification by using silane caused a reduction of scorch time and cure time but an increase in torque difference and swelling resistance. Also surface modification gives better perlite-NR interactions before and after aging. The better heat resistance properties of perlite-filled NR vulcanisates than those of clay-filled vulcanisates is detected from relative property data. Nevertheless a lower percentage of rebound resilience and abrasion resistance of perlite-filled vulcanisates before and after surface modification than those of clay-filled vulcanisates are observed. This is owing to the large particle size low specific surface area poor dispersion and agglomeration of perlite in NR vulcanisates.

This research is to study in heat transfer of hot water tank from an air conditioner which is a cylinder type and has a hot water pipe around the tank. It is used for finding a position and a pattern of distribution of the hot water pipe around the tank in the highest heat transfer condition. The study uses the cylinder of hot water tank filled 45 liters of 25 oC water. An experiment separates in 3 positions of pipe wrapping which are the bottom the center and the top of the tank. Then 80 oC of hot water run thought the hot water pipe which is wrapped around the tank for 120 minutes. The result of the experiment shows that tubing position that causes the highest heat transfer is at the bottom of tank. Pipe wrapping at the bottom of the tank has the heat transfer higher than the top of the tank at 30%. Furthermore this experiment studies in spacing of hot water pipe. There are 3 types for testing which are spacing hot water pipe as one time two times and three times of diameter of pipe. The result illustrates that spacing the hot water pipe can significantly increase the heat transfer. The heat transfer of spacing the hot water pipe in three times of diameter of pipe is higher 5.8 % than spacing in one times. In addition this research is to study in the effect of turbulent flow on the heat transfer by installing agitator in order to stir water in the tank. The result is that water stirring in the tank for increasing the heat transfer is not effective for investment because the energy using for stirring is higher than the enhanced heat transfer

This paper presents an efficient algorithm for optimization of radial distribution systems by a feeder reconfiguration to balance feeder loads and eliminate overload conditions. The system load-balancing index is used to determine the loading conditions of the system and maximum system loading capacity. The index value has to be minimum in the optimal feeder reconfiguration of load balancing. A method based on Tabu search algorithm The Tabu search algorithm is employed to search for the optimal feeder reconfiguration. Simulation results for a radial 69-bus system with reconfiguration and capacitors placement. The study results show that the distribution system with capacitor placement and optimal on/off patterns of the switches feeders reconfiguration can be load balancing in distribution systems.

The objective of this study is to survey consumer behavior’s want in using mushroom replace of fat in the vietnamese sausage. The result of this survey is the choosing Phutan oyster mushroom to use replace of fat. Studying the basic method in producing the vietnamese sausage by studying the amount of fat at 40 60 and 80 grams The result of this the vietnamese sausage that has 80 grams fat because emulsion in the fat makes the vietnamese sausage soft and delicious. And study about the amount of mushroom at 80100 and 120 grams replace of fat The result of this the vietnamese sausage that has the mushroom 100 grams because the vietnamese sausage is the softest and springiness has the weakest smell of mushroom. This compare the original vietnamese sausage with the study on fat replacement by mushroom in vietnamese sausage found that the mushroom vietnamese sausage has the fat lower than the vietnamese sausage 12.78 fold and the most fiber 5.33 fold. Studying self life of the mushroom vietnamese sausage at 5-8.C found that Aw color and the moisture content increase and test about microbe TPC in this product is less than 10 cfu/g and lower than the benchmark (it must be lower that 1x103 for 1 gram). Acceptant the most consumers moderately.