The faults in a power distribution system do not only impact to power outage directly. They also cause voltage sag problem spread over the system. A single-line to ground fault is about 70% of the overhead system faults. The magnitude and duration of voltage sag causes the economic damage of the system. This paper presents an analysis of the different systems grounding to mitigate the voltage sag in a power distribution system by using the technical analysis system in case of one phase to ground fault. The objective is to minimize voltage drop for users using the simulation with single line to ground fault in distribution system voltage level at 22 kV PEA’s test system by the computer program. The results show that the grounding method can mitigate the voltage sag and reduce the damage of the economic system.

This objective of this research is to study the development of the pararubber tapping knife in order to determine the optimum of the edge and oblique angle and to compare the efficiency of the electrical motor and Je-Bong knife. The product was manufactured by iron steel carbon S45C and AISI 5160 with 75-90 degree edge knife and 0-45 degrees oblique angle. The results can be concluded that the optimum condition of the edge knife oblique knife and the cutting force were 75 degree 45 degree and 3.51-51.42 N respectively. It was found that the cutting force was straightly increased form 0-51.42 N and then gradually decreased. The energy consumption of timber cutting was 0.00370 J/mm3. The quality of the rubber tap using electrical motor was 72.07% which was higher than 2.8 of Je-Bong knife. As the results this product shows the average of rubber timber which is 2.22 mm. in 22.51 s.