Nowadays the automotive industry in Thailand has been widely growing. Brake pad is one of the automotive products that play a vital role in automotive industry because it is the most critical seeurity part. Consequently testing products for quality are extremely requested. However the precise equipment and function tests which show the real effects are not available enough and cost a lot. Therefore they cannot response to the deman in the automotive industry development. In this study the frictional test jigs for friction measurement JIS K7125 [5] and the clutch facings for automobiles JIS D4311 [6]. A study of the frictional test emphasizes on the static friction (μs) and kinetic friction (μk) in different condition. There are 3 specimens of brake pad supposted by the industry company. These specimens were tested and the results from the pin-ondisk and those from the friction testing were compared. The results revealed the correspondence of the two-sided results but the pin-on-disk’s friction coefficient is more than the friction testing’s friction coefficient by 19.56%. Moreover the coefficient of friction varies according to the temperature Besides the static friction (μs) is likely more than kinetic friction (μk) and tends to differ considerably under high pressure condition.

Aluminium was used in many industrial applications due to good properties such as ductile high corrosion resistant and high electrical conductivity. Since wear resistance of aluminium was very poor so that it was a limitation of using this material in several conditions. In this research aluminium was improved the wear resistance properties by using anodizing process and adding some titanium dioxide particles on the surface. The effect of anodizing process duration on the wear resistence property was studied. It was found that the process duration and amount of titanium dioxide play the important role on improvement of tribological properties of aluminium.

Aluminum is a lightweight material which are popularly used in various parts of the industry. However there are some limitations on the tribological properties such as abrasive wear and friction when it was compared to other metals. Tribological properties of aluminium was improved with anodizing process and silicon dioxide supplement. the effect of time on surface structure and friction coefficient were studied with with scanning electron microscope and sliding wear tester. It was found that friction coefficient of aluminium was decreased after improvement process was applied.