This research was aimed to study the participation behaviors in the electrical energy saving the factors affected to the participation behaviors and the promotion of the participation behaviors in electrical energy saving of the undergraduate students of the Faculty of Science and Technology Rajamangala University of Technology Phra NaKhon. The participants of 150 students from the Faculty of Science and Technology was also performed based on systematic sampling. The questionnaire was used. The statistical evaluation was also analyzed based on the percentage mean and standard deviation. A 85% of participants is male a range of age to be 19-20 years old (62.7%) second academic years by about 37.3% and a 65.3% of participants has been studying in the major of computer science. Knowledge levels in the electrical energy saving of the most participants are high (13.33%) moderate (62%) and low level (24.67%). The four participation behaviors in the electrical energy saving were analyzed including electrical lighting system air conditioner and ventilator system office electrical system and electrical equipment maintenances resulting in very high level with the average mean of 4.25 and standard deviation of .547. First the participation behavior in the electrical equipment maintenance was very high level with 4.31 and S.D.=.870. Second the participation behavior in the office electrical system was to be 4.27 with S.D.=.828. Third the participation behavior in the air conditioner and ventilator system was to be 4.21 with S.D.=.549. Finally the participation behavior in the electrical lighting system was very slow level with 4.21 and S.D.=.672. By comparing the participation behaviors in the electrical energy saving with the different of academic major of students the participation behaviors in the electrical energy saving did not significant different.

System of The Provincial Electricity Authority using the grounding wire connected between the cable end and Surge arrester format it is connect the cable from the end of the cable set to the end of the Surge arrester and grounded wire that splits the ground between the cable connecting point and the Surge arrester format it is a separate grounding connecting point to the cable end and Surge arrester on both sides of cable riser pole by Computer program. Resulting from computer analysis and the comparison of line setting found that if setting line lead to ground and join with ending cable line and Surge arrester lead in to line voltage drop less than setting line to ground with separate line and Surge arrester.

Ground grid design of substation is very important. It will help prevent the danger caused by the fault which causes the high step voltage and high touch voltage and may cause the operator to die. It also helps prevent damage to equipment and increases reliability for power systems as well. Currently the Gas Insulated Substation (GIS) has been built a lot especially in areas with limited space because it takes less space than the Air Insulated Substation (AIS). In order to create a substation of the GIS model instead of the AIS model. In order to create the GIS instead of AIS including the improvement or maintenance of the substation it is necessary to build another small substation to supply electricity to replace electricity from the original substation. However there are two substation stations in the same area may cause an increase of high-slope ground potential between the ground grid systems of both substations. It will cause high step voltage and high touch voltage while the fault is diminished. Therefore before improvement or maintenance of substation the ground grid distance and the size of the newly constructed substation must be analyzed that what effect on step voltage and touch voltage generation. Including studying the effects of step voltage and touch voltage that will occur.

This paper presents the simulation and experimental result of class-E power amplifier. It is often used in designing a high frequency ac power source because its ability to perform the conversion efficiently even at high frequencies with significant reduction of switching losses. This paper aims to compare the transmission performance of electrical power between the air core transformer and iron core transformer which the identical input voltage of 50 VAC. Both transformers are designed to step voltage up (step up transformer) ratio of 1:4.5. The Arduino microcontroller Arduino was used to generate a pulse width modulation (PWM) with operating frequency of 3.74 kHz. IC gate drive TC4422 was used to drive the IRF510 MOSFET. Based on the simulation and experimental results the power loss in air core transformer is 75 percent while power loss in iron core transformer is 0.2 percent. The maximum distance that can transmit electric power of air core transformer is 9.3 centimeters.

This project aims to create a series of demonstration power plant water. And the operation of the circuit Inverter split by the end of demonstration runs as follows. Theory and documents relating to the source of electrical power water power the working principle of the circuit. Inverter the principle of integrated battery charger main circuit voltage VDC LED LED SMD (Surface-Mounted-Device) a voltmeter. Ammeters digital LCD display couples. Make plans to offer advisors the project approved. Design demonstration kit Equipment supply and assembly Assembly and demonstration the production of electricity from hydropower 220 VAC test run is a series of demonstrations to generate electricity from water power to 220 VAC storage performance voltage and current output. And analyze the results of the operation of the demonstration production of electricity from hydropower 220 VAC and conclusions in this chapter are the results of the experiment demonstrated the production of electricity from hydropower and the conclusion of the trial in order to be used. effectiveness of the objectives of the experimental procedure the results can not load a load test. Test kits demonstration power plant and the demonstration set to produce 220 volts for 25 minutes at a constant voltage. The electricity does not increase or decrease. Always works The term of office is fixed or reduced by the ratio of active power increases.